Search results for query: *

Gentlemen, Many thanks for your help - With your advice and a copy of the manual for the t1 card I have this working. Regards

And doubtless I am dumb to ask... but how do you do that?

I have added trunks to an existing t1. The process looks to have worked but they do not pick up inbound calls. when I issue a tnb command in ld 20 I get the following for a new trunk as opposed to an old. The only difference I see is under the "cls" entry where the second value is "DIP" in...

Thx John, Is there a command I can use yo determine if the Meridian is looking to the t1 for its clock (ie is it master or slave) Im interconnecting the meridian with a shoretel system - the shoretel "looks" like the carrier to the meridian and I would have throught that therefore it should...

We have a T1 card on a Meridan system configured to support 12 trunks. There are more trunks availiable on the T1 circuit - how do I enable additional trunks within the meridian system.

By remote access I meant that we are able to connect to the systems serial port through a PC using Hyperterm and can access hat PC remotely. The system has a NTAK09BA card installed - A cable plugs onto the motherboard which runs to the carriers T1 Interface.

We have a Meridian system with a T1 interface that supports 12 trunks and need to modify the configuration to make the interface operate as a PRI. Can anyone give me some instruction on how to do that - we do have remote access capability into hat system. Thanks.

Can anyone shed light on why any device on the 10.20.60.x network on this router cannot ping 65.124.193.83 or get traffic out of the default gateway at 65.124.193.81 in the config below? I can get voice traffic that comes in over the T1 1/1 to leave via the 65.124.193.81 but no traffic such as...

I have a cisco router with its WAN interface connected to an MPLS enables network via a T1. the output from a show interface serial 0/1 command includes the following... Queueing Strategy: weighted fair Output Queue: 0/1000/64/0 (size/max total/threshold/drops) Reserved Conversations 1/1...

Need to configure a 6509 running IOS to talk to a Netgear 7326POE switch. The netgear has two vlans. Vlan 10 is tagged, vlan 30 is untagged. When vlan 30 traffic leaves the Netgear it is tagged as Vlan 30 - Vlan 10 traffic is, of course, already tagged. The netgear box is attached to the 6509...

Andrew, You have a very good point - and of course the answer is that I should not be doing it this way at all. Thanks for your reply - it led me to the right answer.

I need to configure a core switch which is connected to two switches located on two floors of a building. Floor 1, attached to Ethernet 0/1 on the core switch has two vlans : Vlan 60 192.168.51.1 (Data) and VLAN 100 - 192.168.3.1 (Voice) Floor 2, attached to Ethernet 0/2 on the core switch has...

We have a Pix with an external IP address of xx.yyy.15.90 (255.255.255.252) and an internal address of 10.20.30.150 (255.255.255.0) The Firewall has a static route to another internal network 192.168.80.0 via a gateway 10.20.30.80 Our ISP has provided us with a range of public IP addresses...