Recent content by SenorAvayaGuy

@gwebster is that only for 9608's or is this for any 96xx series phone? @sean655 Yes, i found this to be the only temporary solution as well, unfortunately i don't want a screen filled with call appearances or any unnecessary buttons on phone, seeing i'm using a button module for all abrv-dials...

Good afternoon my fellow tek-tip users, i'm encountering a problem where i'm trying to program an "abrv-dial" on a 9608 5th button on a 6.3 CM. Here's the issue i'm encountering, when i place it on the 5th button.. if there is nothing using the 4th button it moves to the 4th button. i'm...

As a side note, the G450 used the same IP trunk as the G600 (We just changed the IP to point to the G450).

I wanted to say the same, But makes no sense why the old setup (G600) can make calls via the IP trunk to IPO through SIP but G450 Cant. As much as I want to say its provider, I cant fully. And As much I dont want to say its my config... I dont believe it is my config lol. I literally Mirrored...

Not sure out to export IPO information. not like good Emulation, anyhow. Getting late and Ill probably escalate the situation tomorrow. Ill Keep you posted ! thanks for all your help Joe

Just full number without dialing 9 as an outside access code

Yes outbound calls from IP phone registered to IPO work perfectly fine, And IPO routing doesn't need a 9 to dial out (or they must be implementing in a route) I even stripped my 9 via route side (on G450) to see if something weird was happening with what was being outpulsed. No luck.

Nothing shows on the trace, Not the trunk between the two (IPO and G450). Nor on the SIP trunking either. I would post if there was any thing that showed. Unfortunately there isn't anything showing. Ive hit a dead end, friend lol. I cant think of what it could be thats denying my call and...

Thank you for posting, twas an interesting read lol

No, This is a temporary implementation. I was trying to get rid of the current G600 with exact same config (and was working with integration of IPO) and place the G450. Although, this is giving me a headache. I want to point fingers toward IPO but not experienced in IPO to say configuration is...

Entered in both Private and Public, still denying me.... Any other ideas ?

Yes just tested with the number placed into Public unknown and its still spitting out the denial event. Banging my head on the table at the moment lol. And I did a trace in IPO and the IPO doesnt see the call even hitting its SIP trunk.

Hello users, having issues I hope you can help with. I'm trying to get a call out through a sip trunk from IPO via an IP phone from G450 (IPO is being median for sip trunks as 450 has no SBC controller) Here is my config. Group Number: 2 Group Type: isdn CDR...

Hello folks, Hopefully you can give me some insight and or helpful tips. Example: I am trying to get whoever call's xxx-xxx-xxxx to route into my PBX, then from the PBX to manipulate the call to hit 2 different numbers simultaneously (Cell Phones) I've tried making 2 IP phones with EC500...

Telecomadmin12, I'm afraid "completely different problem" isn't correct. Actually both problems are trying to call SEVERAL REMOTE NUMBERS SIMULTANEOUSLY. Using a VDN is just another way at attempting to do the same thing I am trying, I also mentioned using EC500, Is that not the topic of...