Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rlance610

  1. rlance610

    Malaysia ARS example

    I am looking for an example ARS setup for Selangor, Malaysia. I was able to find a few pages about dialing properies there but nothing that was all inclusive. Thanks in advance.
  2. rlance610

    Intuity LX 1.1

    I am getting an error "no instance number available." Logging in as vm with 4410 and 513 emulators. Has anyone seen this, know a fix? Any help would be great. Thanks.
  3. rlance610

    OSPC (New IP Console)

    Check out this document, it should help out with the importing: http://support.avaya.com/css/P8/documents/100065247
  4. rlance610

    Converting MCC from DS1 connection to IP connected

    I am trying to convert an old MCC carrier from DS1 connection to IPSI control connections. I have been looking for a while for a diagram on how this looks with no luck. Is there anyone out there that has something that I could take a look at? Or a cabinet layout? Thanks R
  5. rlance610

    Call Timers on 4610 - 4620 Sets

    I have a customer that has 4610's and 20's Ip sets. When a call is made the call timers starts on the display and when the call end the timer keeps incrementing. Does anyone have any knowledge of this and how it may be fixed? All of the phones are at the latest firmware 2.9. Thanks for the help.
  6. rlance610

    S8720 Service port not responding

    a ping and telnet
  7. rlance610

    S8720 Service port not responding

    Yes and Yes
  8. rlance610

    S8720 Service port not responding

    port 1
  9. rlance610

    S8720 Service port not responding

    I have yet to load any software, thats what I am trying to get done. I have statically applied 192.11.13.5 to my PC. Still no response for the services port.
  10. rlance610

    S8720 Service port not responding

    Hello everyone! I have been looking at this for a little while and figure I could throw this question out to everyone. I am trying to load a new S8720 with CM 4.0.4 and the service port is not responding to anything I do. Does anyone have a suggestion on how I can fix this? Thanks for the...
  11. rlance610

    Update service pack on S8400

    Since both are cold patches, there will be a reset system done at both the deactivation and the activation. Hope this helps!
  12. rlance610

    Update service pack on S8400

    update_deactivate 730 patch then update_remove 730 patch then update_unpack 731 patch and finally update_activate 731 patch. Thanks. Randy
  13. rlance610

    g250 fails to register after reboot

    Make sure there is a "copy run start" done on the G250, before shutting down the gateway. That wrights all the changes into flash for the G250.
  14. rlance610

    MM314 POE issue

    Everyone, I am working on a G350 with a MM314 (24 POE switch) and the gateway/mm are having some troubles. I am getting a "workQPanic: Kernel work queue overflow" whenever I have the module inserted. When I take it out the g350 boots normally. Has anyone run into this before, and if so how...
  15. rlance610

    "Resources Unavailable" on Display

    I would also check the speed and duplex setting on the network switch and the ports in the G700.
See more

Part and Inventory Search

Back
Top