Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by PPCLI

  1. PPCLI

    Mitel 3300 DPNSS link to INDeX

    You can tenat trunks in the trunk assignment form
  2. PPCLI

    Backing up RAD greetings

    When you use winzip or another program backup.tar\\vmail\temp\db\backup\vmail you will see *rad001.vox *rad002.vox this is your recordings
  3. PPCLI

    Starting Mitel

    For ISDN E1 it is the same as for ISDN PRI on a Mitel
  4. PPCLI

    Call Pilot 201i

    hex continues to scroll host. Older 201i hard drive ok I can put in another 201i. Monitor ok works on another 201i
  5. PPCLI

    Call Pilot 201i

    yes no video at all cant reimage
  6. PPCLI

    No Audio on PRI

    Its pretty hard to install rel 5 improperly I am trained on rel 5 and wrote the exams. One cabinet with PRI. only programming in system was a PRI and AMWLC and the min requirrements to make a call out plus the tds and conf and dsp. I like release 5 and the ip connectivity but we had an issue...
  7. PPCLI

    No Audio on PRI

    Sorry didnt get notified of responses there was corruption in sw had to reload. This new rel 5 is a charm Thanks to all who replied
  8. PPCLI

    CS1000E Rel 5

    Turns out the set came with vlan 1 hard coded removed and set to no vlan all ok
  9. PPCLI

    Call Pilot 201i

    No video went thru nortel recommended steps remove ram etc no good starts up t01 thru t08 no errors scrolls at host anyone had any success with this.
  10. PPCLI

    Mitel SX2000 - Remote help hooking up E1

    Who is the network side? Is it E1 pri? or qsig?
  11. PPCLI

    Auth code

    Thanks John did what you said worked like a charm
  12. PPCLI

    Auth code

    If I change the rlb prompt mfrl can I have it so only sets that are set a an ncos too low for LD to get prompted and all else not. Or is there another way
  13. PPCLI

    8600 Help

    When running an install again I get an error master and standby config must be on the same subnet. anyone seen this I only change the settings that are on the main install I do not see a master and standy referenced
  14. PPCLI

    8600 Help

    Does the management port require a special cable
  15. PPCLI

    8600 Help

    Thank you to all

Part and Inventory Search

Back
Top