Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Phoneyguy1

  1. Phoneyguy1

    Modem access

    I don't think Hypertermal has been on Windows since WIN7
  2. Phoneyguy1

    Modem access

    Thanks Firebird I will try your suggestion. If that doesn't work I think I will remove Win10 and install Win7 on my new laptop
  3. Phoneyguy1

    Modem access

    Help! Does anyone know how to access a meridian switch using Windows 10? My old laptop is on its last legs and I need to replace it. I've used Procomm Plus on Windows 7 but can't seem to find a solution with Win 10. Any ideas. Someone else must have run into this issue.
  4. Phoneyguy1

    T1 SLIPs

    Both ends are setup the same. Found that Bell was working on circuit and the 11 went into Free Run . Locked it to PCK and it's now running clean. Thanks for the support.
  5. Phoneyguy1

    T1 SLIPs

    it is a PRI w/ DCH. Dual PRI card at the 61 and a DTM/PRI at the 11
  6. Phoneyguy1

    T1 SLIPs

    I just installed a Point to Point T1 between an Opt 61 and a Opt 11. I keep getting frame errors, SLIPRP that I read is repetitive framing errors but I don't know what that means. Bell says its not with there circuit. Any ideas what is causing this?
  7. Phoneyguy1

    T1 SLIPs

    I just installed a Point to Point T1 between an Opt 61 and a Opt 11. I keep getting frame errors, SLIPRP that I read is repetitive framing errors but I don't know what that means. Bell says its not with there circuit. Any ideas what is causing this?
  8. Phoneyguy1

    Distribution Lists Call Pilot

    Thanks for the info on SDL's. I'll check it out.
  9. Phoneyguy1

    Distribution Lists Call Pilot

    Thank you for the info. Customer knows about CP ports but wanted to set up anyway. Thanks again!
  10. Phoneyguy1

    Distribution Lists Call Pilot

    Understood but customer wants to send by CP. They need to notify large groups in different areas at one time.
  11. Phoneyguy1

    Distribution Lists Call Pilot

    I've looked but can't get a answer in NTP's. Are there any limits on the number of MB in a distribution list. I need 300 plus. don't want to broadcast.
  12. Phoneyguy1

    911 printing

    Thanks, I will try that and post how it worked.
  13. Phoneyguy1

    911 printing

    That's what is the problem. If I remove the terminal from the parallel port and hook up the printer it will not print.
  14. Phoneyguy1

    911 printing

    My customer says that at one time they printed all 911 calls to a dot matrix printer only without a terminal attached. I can get the printer to print 911 calls but I must use a printer attached to a terminal. Is there a way to just print to a printer only?
  15. Phoneyguy1

    MerMail Broadcast Message

    Thanks guy's for the help. Nothing worked so I had to re-load the backup to clear the broadcast message.

Part and Inventory Search

Back
Top