Search results for query: *

I don't think Hypertermal has been on Windows since WIN7

Thanks Firebird I will try your suggestion. If that doesn't work I think I will remove Win10 and install Win7 on my new laptop

Help! Does anyone know how to access a meridian switch using Windows 10? My old laptop is on its last legs and I need to replace it. I've used Procomm Plus on Windows 7 but can't seem to find a solution with Win 10. Any ideas. Someone else must have run into this issue.

Both ends are setup the same. Found that Bell was working on circuit and the 11 went into Free Run . Locked it to PCK and it's now running clean. Thanks for the support.

it is a PRI w/ DCH. Dual PRI card at the 61 and a DTM/PRI at the 11

I just installed a Point to Point T1 between an Opt 61 and a Opt 11. I keep getting frame errors, SLIPRP that I read is repetitive framing errors but I don't know what that means. Bell says its not with there circuit. Any ideas what is causing this?

I just installed a Point to Point T1 between an Opt 61 and a Opt 11. I keep getting frame errors, SLIPRP that I read is repetitive framing errors but I don't know what that means. Bell says its not with there circuit. Any ideas what is causing this?

Thanks for the info on SDL's. I'll check it out.

Thank you for the info. Customer knows about CP ports but wanted to set up anyway. Thanks again!

Understood but customer wants to send by CP. They need to notify large groups in different areas at one time.

I've looked but can't get a answer in NTP's. Are there any limits on the number of MB in a distribution list. I need 300 plus. don't want to broadcast.

Thanks, I will try that and post how it worked.

That's what is the problem. If I remove the terminal from the parallel port and hook up the printer it will not print.

My customer says that at one time they printed all 911 calls to a dot matrix printer only without a terminal attached. I can get the printer to print 911 calls but I must use a printer attached to a terminal. Is there a way to just print to a printer only?

Thanks guy's for the help. Nothing worked so I had to re-load the backup to clear the broadcast message.

Here's the thing. it no longer plays the broadcast message internally but does play when you call from outside to a DID. 76 will not delete from there and I can't figure out why or how it plays on incoming calls.

Thanks Gene, I'll try that. 76 will not work during message. I get "Delete feature is not available at time". Once the broadcast message plays it goes directly to the mailbox message options. Is that how it is supposed to work.

Does anyone remember MerMail? For the first time in 30 years someone asked me to show them how to broadcast. The issue is that I recorded a test message to 5555 and now we can't remove/delete the message. We tried 76 but that will not work. Is there a procedure or a different code for...

My customer wants to remove 9911 and only dial 911 to get E911 services. They now dial 9 to go out but want to only dial 911 to get E911. Any ideas?

I have two existing conferance bridges set up but need to change to a dual bridge. I don't understand the NACD programming. Any tip or tricks to set up? Any help would be appreciated.