Recent content by netechsys

Hello there, I have a PIX 515E fail over pair, and am trying to setup a multi-pathed internet connection with the following config: FE0 - Outside - Static IP 160.1.1.X / 26 (1st 64 address block) FE0.1 - Outside 2nd - Static IP 209.172.x.x/26 (1st 64 address block) FE1 - Inside - Non Routable...

Hello there, I have a PIX 515E fail over pair, and am trying to setup a routable DMZ on a port. I have 6FE's, with the following config: FE0 - Outside - Static IP 160.1.1.X / 26 (1st 64 addresses) FE1 - Inside - Non Routable IP address 10.1.1.1 / 24 FE2 - Client - Non Routable IP Address...

If you are recording Digital Extensions now, you would have a NATI card. Analog requires an ALI card. It would also take a reconfiguration of the software to use the new card. Sorry. NetechSys

I have an Intuity Audix 5.1 system running, and want to use the Internet Messaging that is enabled on the system. What else do I need to get it to send messages to my end users? Any help is greatly appreciated. Thanks. Netechsys

In the next generation of Perform, Perform II, NAT will be supported. In the surrent versions, NAT is not supported, unless it is a one to one static NAT. Netechsys

Hello all, I am trying to setup the Internet messaging part of an Audix 5.1 system. It refers to 2 trusted servers being needed. Is there a way to send only outgoing messages through a SMTP server? I only want outbound messaging. Any help would be great! Thanks in advance!

With NICE there is a few ways to do this. There is the Agent ROD, like the Witness. There is also a few ways of recording these types of calls, but it depends on what type of logger you have. If you have a Digital or Analog recorder, you can setup a phone to auto answer, and put a speed...

Ok, you do not need to stop the CLS to look, only change. Going on the idea that you are using a Nortel: If you look in the c:\NICECTI\INTEGRATION directory, you will see a few files. The ones you want to look at is the mapping and the devices files. If the mapping file, when you open it...

The question needs to be asked, what are you using the system for? Compliance or QA? What type of redundancy do you require, if any? What type of Switch / CTI / Solution are you looking at? Digital Extension, Trunk, Service Observation? I ask these because the solutions are quite...

If you are using a 8.x VL that has the old style LAF card, you can also setup one logger to be the host time source.

Ok, I have finally gotten into the office. The switch is a G3V6i.03.1.230.6. Any help would be greatly appreciated! Thanks. NetechSys

To back up the Media library, all you need to do is back up one directory from that machine. C:\dat_lib There is a backup that runs on the machine that backs it up to the dat_old directory, but if the hard drive fails...... If you backup dat_lib directory, your good. Thats it. Just that...

Is there a way to post a PDF to the forum? Please advise!

I agree.. This has been a big pain since I started using it. As for the Supervision changing the time, it too is a pain, and only works from time to time. It seems that the newer version do not work that great, and I end up changing the time manually as well. They have a solution for it...

Ok, Here are a few things that catch my attention.. The loggers are onthe 3rd floor, and the stations are on the 15th floor.. So, using riser pairs, I would estimate the cable runs to be about 175' at a minimum to go from the 3rd to the 15th floor. With the addidition of any routing and MDF's...