Recent content by NECPBXtech30

Thanks for the replies, I have tried both commands without results. Do you know if there are any ASYD bits that need to be flagged for this feature? "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

Is there a way to change or block the out bound caller ID on a per station basis? I know you can change the entire route caller ID using ACNP and ACND. But I need to block about 80 phones from sending caller ID info. System is SV8500 with PRI service. Thanks for any input... "However...

Check ASPA in the ACC put 25 (or However you have the number group broken out) in the CI input N for normal. the SRV should read STN and the NND should be the number of digits for your extension number. Confrim the same settings are there with the CI changed to "H" and "B" If they are not the...

you can list all of the LENS using the LLEN command. It will give you all LENS and will have data next to the LENS that are in use. "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

the command for setting the message waiting indicator is CMWL "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

try pressing feature then the answer key so it stays lit. "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

the first thing to do is to identify which system we are dealing with is it an IPK or IPK II? the following is for an IPK... First identify the port you are dealing with... go to the trouble phone and press the Feature key then the number 4 you should get something like TEL01=100 write down...

Does anyone have a cheat sheet for programming an MH250 on an SV8500? We have four of them and i am absolutely clueless where to start... thanks for any input. "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

i am not familiar with MAID...if you get data when you put in 919 that is the issue. 919 in afrsn needs to be deleted before you can break it out. "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

did you delete the original 919 entry first? that has to be done before you can break the sequence down further. can you list afrsn and post it? that would be helpful. "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

how did you break it out? if you have an entry for 919 then you will have to delete it and break it out from that point... 9190 91910 91911 91912 91913 91914 91915 91916 91917 91918 91919 9192 9193 etc... "However beautiful the strategy, you should occasionally look at the results." Sir...

I would also check the number you are hotlining to... "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

That is sort of a general question. could you be more specific about what it is you want them to do or not do? "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill

if you have an exitsting main greeting that answers, call the number from the outside, when the auto attendant picks up dial 9632. (as gbaughma stated) that should get you to the system manager box. Assuming you have a dos based VMS or VMP... once in the system manager box listen to the prompts...

have you checked the indicator lights on the front of the box? When all else fails unplug the unit and try to delete. "However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill