Recent content by murphymouse

phoneguy427 Do you mean set prime line to an outside or intercom?

Thanks I was hoping their was a factory restore. I will change DN

Do you know how it's done?

So it can take a new extension?

Have setup up telephone with no issues, know Intercom DN I plug in ATA and nothing on the analog phone.

Can an ATA be used from jack to jack to get a roaming analog connection? Will relocation allow it to always be the same extension # DN

Can this be done

Right now it want sot go to AA

Solution was that the Ci card was in the left slot on the KSU instead of the right side. slot 1 for lines 001-004 is on the right not the left. Oversight.

Caller ID turned on...as per the installation guide...any tricks i might want to know?

Telco has confirmed caller ID...a swap may be usefile Thanks

Forgot to add...we tested the the CI card that is not producing the results we would expect in another system...it works fine.

The lines even show up on some sets with black deltas showing in use...they are not though

I understand it that you want to have two telephones with the same extension. You have an existing phone extension using two wire. I would double check that it is two wire, because 2, 3 & 4 pair are more likely. Why would you want the same extension at the smae physical location. You could...

Have a MICS system shared by 2 or 3 separate users...each with 2 0r 3 sets and lines. Have 2 CI cards in the system, yet only one of the cards is allowing the caller ID to be active. the other set (001-004) cannot get the caller ID which seems to be set the same as the the CI card in the...