I posted a same type of question a while ago. I thought there might be a new updated software available which could import snapshots in form of OVA at remote computer.
There is no such thing as a free LUNCH.
Hi All, we are using CM 8.1. with Mix of Avaya IP and SIP phones. All phone are saving incoming call logs with access code "9". However our dialout access code is "8". User cannot dialout from incoming call log since the icoming calls are saving with prefix "9". How can i change this to "8"...
We are planning to test third party SIP phones (Yealink, DLink, CISCO) with our Avaya Aura CM/SM/SMGR release 8.1.
Anyone had any experience installing the same sets with avaya? can somebody share their experience and tips/doc for setting up these 3rd party SIP phones with all feature working...
We are planning to test third party SIP phones (Yealink, DLink, CISCO) with our Avaya Aura CM/SM/SMGR release 8.1.
Anyone had any experience installing the same sets with avaya? can somebody share their experience and tips/doc for setting up these 3rd party SIP phones with all feature working...
Hi it is CM release 8.1 with mostly J series sip phones. We are facing call transfer/conference issue. The transfer/Conference feature/button does not work until the called part answer the call, both feature only works if call gets connected with the called party.
Any help??
There is no such...
Hi Kyle, this system was upgraded recently. Before the upgrade they were using Avaya digital phones and never faced such issue. It happened after upgrade and Tel set replacement to new J series phone with H.323 firmware. The Configuration is same as of old replaced avaya. The only difference...
Thanks Kyle for the tip. I was also searching and reading the technical solution available at Avaya support and few post were referring the Tone/Cadence changes and disconnect supervision option.
Cannot open a ticket with Avaya as system is not under contract.
I will check your tip. Anybody...
Hi,
We are using four J169 series phone (on H.323 firmware, Latest) with Button module. Each J169 user has one CO line specifically assign to ring that extension.( four routes having a single CO line)
First Route, lets say Route A , Incoming Destination is set to = Ext-A
Three other extension...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.