Recent content by Ired1980

Hope so, but I think that what you're talking about is just wishful fillment. ------------ Telephony communication is like an air: you do not notice it until you spoil it.

Try to change COS of this Extension. PGM 602 -> Enter -> Extension No -> COS (01-64) -> Enter ------------ Telephony communication is like an air: you do not notice it until you spoil it.

This is a usual problem for combination of analogue CO-lines and DISA. There are 3 ways to solve such problem. 1) To use "Calling Party Control (CPC)" or "Polarity reverse" feature of PBX (if your TSP supports one of them) 2) To use an external device such as "Busy tone detector" that should be...

That is correct only in case if users of remote sites (B, C, D, E) need to communicate with Site A only. If they need to communicate with each others, VPN should be full-mesh (every site to every site) in case of TDE-series systems. ------------ Telephone communication like an air: you do not...

Program -> DSS_Button -> X -> YYY -> Store, X - Feature of DSS_Button: 0 = CO-Line to control 1 = Extension to control 2 = One-Touch Dial "Transfer" = Clear selected DSS_Button YYY - Parameter of X: if X=0, YYY - CO-line number (See WEB Maintenance Console -> PBX Configuration ->...

Switch on the Port mirroring on Mikrotik and then get IP-trace with the WireShark. ------------ Telephone communication like an air: you do not notice it until you spoil it.

DTMF type at your PBX has to match with DTMF type set by your SIP provider. Also SIP provider has to use only one type of DTMF sending. Try to select DTMF at your PBX side. Probably you'll be able to solve the problem. ------------ Telephone communication like an air: you do not notice it...

Well, describe to us (step by step) what are you doing and what happens after that. Did your PBX ever work? ------------ Telephone communication like an air: you do not notice it until you spoil it.

Have you completed the initialization procedure? Also note: when a DSP card is installed and DHCP server is not connected, the DSP can't obtain an IP-address, ans STATUS indicator turns red (see Installation Manual, paragraph "4.13 Starting the PBX"). ------------ Telephone communication like...

You have to use "Local access" code (9 or 0) to get an access to PSTN ------------ Telephone communication like an air: you do not notice it until you spoil it.

Yes, it works. ------------ Telephone communication like an air: you do not notice it until you spoil it.

Try this link. https://www.panasonic.com/middleeast/en/support/contact-details.html ------------ Telephone communication like an air: you do not notice it until you spoil it.

what version of PBX do you have now? ------------ Telephone communication like an air: you do not notice it until you spoil it.

Also, if this phone connected to DLC card (not MPR card), you need to upgrade DLC card too (to ver. 8.01) ------------ Telephone communication like an air: you do not notice it until you spoil it.

Note 1: I'm not sure about solution below. Let's wait for comments of collegues. Note 2: First of all you shold ask your distributor about this case. Did you compare files of your original SD-card and TDA0920 card? AFAIR, TDA0920 card include an additional files for extended features. If I'm...