Recent content by gsdelong

New Data, it looks like it is related to calling plans. after monitoring the dchannel I go the following DCH 19 UIPE_OMSG CC_SETUP_REQ REF 000011FA CH 19 23 TOD 12:53:08 PROGRESS: ORIGINATING END IS NOT ISDN CALLING #:317352xxxx NUM PLAN: E164 TON: NATL CALLED #:317670xxxx NUM PLAN: E164...

SEE ENXT POST I have multiple sets that send out only the ext# as caller id. I know this is normally controlled by CLID table So I have a DN that works correctly when the TNB has key 01 SCR 1994 0 it gives the proper 10 digit caller ID When I add that DN on one of the sets that is sending...

Ok maybe I misunderstood but I tried creating a new entry I have the same issue it automatically populates the ESA_APND value as yes with no ability to change it.

I have a single entry for CLID and I am unable to use load 15 to change ESA_APDN to NO after typing 0 on entry t steps through the values until it gets tot ESA_APDN and then just allready has a yes and goes to the next line. Do I need to change something else first. I am trying to have all...

Option 61 Hospitality Modules, Meridian mail How do I change the wake up call greeting? Thank you

I have set up a DN as MCR that forwards to VM after 4 rings on 6 phones. It is now being reported that not all the phones start ringing at the same time, and one of the phone only gets to 2 rings before they all stop and the call is forwarded to VM. Anybody have a clue where to start looking...

I had a client today that wanted to dial the phone number 317-800-XXXX The phone switch choked on it trying to dial it as a local (since that is our area code) 9,800-xxxx And as a long distance 8,317-800-XXXX I am assuming that the 800 exchange is causing the issue? Any thoughts on how to make...

I have a phone that the line ringing indicator "little arrow on display screen" on a 3905 stopped working. any ideas or is this a display issue? thank you in advance Greg

Firebirdscrambler thanks for the reply, but even so what does it hurt to delete the KEY00

I have a CS1000 Switch which we no longer have the symposium server connected to. I have a TN that still has a ACD set as KEY00 can I just nuke that key? I am assuming that the database we are worried about is the Symposium database, not the phone switch? Thanks Greg

trvlr1 thanks for the reply. I did exactly what you said bit I am still confused if you look at my original matrix I have 2 loop 4 shelf 0 -3 in different cabinets ( I think). Does the LDIS 4 0 command query both cabinets at the same time? [/indent]S0 S1 S2 S3 LOC DIS RGTP 01 004 004 004 004...

I appreciate the response but it does not really answer my question about what appears to be 3 cabinets in an option 61 it looks like I would need to run 12 queries not the 8 that I can figure out?

I think you are operating under a false assumption. The port most likely will not give out he same IP address which would be handled by your DHCP server not the switch. I say most likely because DHCP lease have a time to live and it is usually set in hours.

Without the switch model here is the only information I could get. Are both locations on the same physical network? Are you you using fixed IP or DHCP? If you are using fixed IP and both locations are not on the same physical netowrk I would guess you have an ip conflict This is with the leds...

There is a linux live CD that contains an utility for changing the password. Here is the link: http://pogostick.net/~pnh/ntpasswd/