Recent content by Drew2400

Reading the FCC notification, this only effects the locations with 988 in the local exchange. I would think, however, that at some point we're all going to have to transition to 10/11 digit dialing.

I believe you also get extra features in Avaya Aura Messaging (AAM). Like dial by name, web access, etc.

Okay, so I've been banging my head against the wall for a few days now. In Workplace (IOS and Vantage), when a caller calls, the Cover Group Name displace instead of (or in addition to) the CallerID. In the log, however, it displays the CallerID after the call has been presented. So if you...

I've been looking around at SBCs. I thought I read somewhere that Avaya was coming out with an Aura SBC for IPO. I've even looked at open source. Any suggestions?

With that being said. I do intend on implementing a session border controller at some point. Just as an FYI. I guess you do need an IP address then in the trunk config.

Okay... Having had a chance to read this, perhaps I wasn't in my usual fine literary mood when I typed this. I think I can clarify. I want an ITSP to be able to dial a SIP URI on my switch "directly" without the need of passing through another ITSP. Like dialing 100@domain.com or...

Interesting question. Is there a way to setup the IPO so that you do not require an ITSP for incoming? Let's say for instance that I purchased a line from someone (analog for reference) of 14135551212. Can I allow any SIP provider (that is not a sip provider currently) to call the number at...

Okay... Before everyone jumps all over me about asking this question that has been asked in the past, I want to say this is not an HR issue. You can't say "fire the person who gives out the number"! That simply isn't going to happen. There are circumstances where we need to block the CLID on...

Well, that's certainly good news. Hoping it hits the support site relatively soon. I don't want to have to pay for windows and av. Take care, Drew

I think, like most people, I was trying to avoid a windows license and anti-virus by going with the App Server. I am a bit disappointed though. It doesn't seem to work very well. I still can't see the message times or play them on the iPhone. However, if I get a new message and press play...

Much appreciated!!!! Take care, Drew

No. It says that it's not configure and I must listen through the phone. Odd....

Okay, I un-ticked the UMS and magically my messages showed up. However, I can't play them. Hmmmmm. When I hit Play, nothing happens. Also, there is no time estimates on the VMs. Drew

I'm running the Linux based Admin/One-X/VM. Is there a web VM for the Admin Server? And, yes, twinning is checked off. Interestingly enough, I noticed that my user has UMS checked off. Perhaps an un-tick? Drew

I downloaded and installed it yesterday. Interesting though. I leave myself a voicemail and nothing shows up. I can't see the list of VM's nor can I listen to any new ones. Anyone else having that issue? Drew