Recent content by burak28

is it possible to learn bios version of an cppm cs card without booting card up ?

it is not working... which port should i use to connect MGC ?

i am unable to turn MGC setting to factory default, when i connect to com port i see nothing , just unable register to primary callserve messages. Can you advise me on this ?

hi all, i have to load a database from floopy diskette to option 61c 4.5 system. can you tell me the procedure ?

I'd like you to confirm the expected contents of a CDR L record The call setup is : Extension A rings Extension B Extension B has Call Forward No Reply set to Call Pilot IVR The call is dealt with by IVR and the call clears In the CDR L Record we have the DN of Extension A and the Call Pilot...

ip phones S1 is SCS Node ip, IP phone is redirected properly through NRS NCS, but when the ip phone register first time Invalid ID (3) shows on the display, once any key presses the error replaced with User:DN which showes that the phone is redirected to the Pcs. if we leave the phone for some...

you can not access the tn information from registry

yes if you load the patch you can use redial function but it is PI patch and chargeable

MPLR 26722 fixed the problem . Thanks

Is it possible to change the "Call Force Tone" on a CS1000E rel 5.50 (CPPM Call server)? LD 56 - ACFT prompt. It is possible to change this ACFT prompt on a CS1000M multi group rel 5.50 and on a CS1000E rel 6 (beta trial). If I try to change this on the CPPM rel 5.50 it is not possible. The...

Hi all, My system is rls 5.0 When phones forwarded to a private mobile network (4 digits) (of an external carrier) and when incoming call comes to one of them, the calling one does not receive any calling tone. This same thing is not happening while phones are forwarded to a mobile (9 digits...

hi , for rdl problem you need to purchase a PI patch from nortel

Hi All, NTP for the upgrade from Meridian 81C CP4 FNF to CS1000M MG PIV FNF Rls 5.5 and i cannot find it I only can find the next NTPs but there are not my case. NN43021-469_02.02_81CCP4FUP.pdf Communication Server 1000M and Meridian 1 - 81C IGS to CS 1000M MG CP PII FNF Upgrade...

thx,problem after changing clid parameter from opt0 to opt 1 on the related DCH.

Kindly we need support to solve CLID issue on tie route with Cisco access server (ISGF DCHs ). The problem is when trying to initiate outbound call on route 59 from any set configured with scr key entry 18 the number on this entry which supposed to be received by Cisco is 414113999 , but this is...