Recent content by broncos1112

Yes, I am using the paging port out of back of 3300 server. And I have had the audio cut out using a butt set plugged directly in to back of server. Again though, inconsistent.

Has anyone seen this problem on a Mitel 3300 IP system? Whenever customer pages over speakers the audio drops for approximately 5 seconds. The call does not drop, if you keep talking the voice will be heard over speakers again. This is an intermittent problem. I have replaced the analog adaptor...

Trying to add an attendant console to CS100 Media Gateway Branch office. Cannot get it to work.Has proper SLT. Documentation does not mention M2250 as being compatible. Has anyone installed M2250 on a branch office? Any ideas? Thanks

Adjusted timers. Also took inc. DID calls out of the equation. Could not transfer an internal call from BCM phone to IP phone to BCM phone. Any other ideas anyone?

Here is scenario. Incoming call to Ext #1511 via PRI Did trunks. X1511 is an IPset (1230 type). Try to xfer call to other ext #1504 which is a 7208 type phone off of BCM 200. IP trunking involved. CS1000 Pbx is the main site with media gateways, Opt 11, and bcm 200 and bcm 400 tied together...

Thanks guys for the info. That worked.

Here's the scenario: Recently upgraded school system. cs100E to 5.0. Off site elem schools converted to cs1000MG. Loops 4-0 and most recent Loop 4-1. The recept phone and admin phones are 2616 type. 2nd incoming call (while on key 0 on another call ) beeps once, doesn't continue to ring, while...

Thanks for the input from everyone. Customer is OK with the ability to access pbx via Virtual Term. He doesn't need H.323 license for now.

I completely agree with John Pooles assessment of OTM/TM. Procomm is much easier to deal with.

Try to avoid it if at all possible.

Yes, it is added in Element Mgr. I think it may be a problem with no H.323 licenses in switch. Thanks

Yes I'm having trouble establishing that link. How do I do that? Thx

New install CP-PM Sig Server. Green LED keeps blinking. I have re-installed software (Succession 5.0),swapped out, elan patch cable, and of course rebooted several times. I can ping IP address via Ld 117, and can also get into Element Mgr via Tlan. I can also get into switch via virtual term. Am...

Thanks 56BelAir. That is what I was planning to do also.

Issue with call pilot 4.0. Large city gov't. customer. Getting complaints of delayed message notification. Intermittently, no pattern established. Not even the same ext #s. Is there something in settings to change? Or a patch for this? Any ideas anyone? thanks Mark Lee/Copperstate Comm.