Signalling Server/CP-PM will not fully link up

[broncos1112]

New install CP-PM Sig Server. Green LED keeps blinking. I have re-installed software (Succession 5.0),swapped out, elan patch cable, and of course rebooted several times. I can ping IP address via Ld 117, and can also get into Element Mgr via Tlan. I can also get into switch via virtual term. Am I missing something? Any ideas anyone?
Thanks MLee. Copperstat Communications Phoenix

 

[allenmac]

Flashing green indicates the link to the pbx (active call server) is down.

 

[broncos1112]

Yes I'm having trouble establishing that link. How do I do that? Thx

 

[MikeRizz]

In Element Manager did you add the Sig Server to the Node ? If not, you need to.

 

[tnphoneman]

Most of the time you transmit the configuration and this will fail the first time then reboot the server and transmit again. The first time only sets the IP address.

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[broncos1112]

Yes, it is added in Element Mgr. I think it may be a problem with no H.323 licenses in switch. Thanks

 

[dulfo666]

You dont need H.323 licencs to use a sig server.

 

[teekow]

you don't need them to use a sig server, but you need at least one in order for the link to fully establish..........

element manager should work fine........your problems will occur if you ever have more than one MG since your DSPs won't register unless the pbx link is established.....

good luck
rob

 

[Eddie79it]

Check in SS CLI if you got an error like " COMUNICATION SERVER SW not correct -> Upgrade call server software".
I had the same problem in a cs1ke and I find a specific patch on nortel Site.

 

[phones1]

what are you doing ? are you adding a follower or installiing a new leader?

Remember if it doesn't work hit it harder

Scott UK

 

[broncos1112]

Thanks for the input from everyone. Customer is OK with the ability to access pbx via Virtual Term. He doesn't need H.323 license for now.