Recent content by billybobdan

It sounds like the SNMP agent is having trouble

No is too harsh,, yes but not at 1 gig would have been better.. How do I edit ?

No max is 100

You need a login with higher access level

Look into the cost of agent boards. These are software that reside on agents PC and displays the stats on the users screen. Licensing is the cost involved, maybe you already have some.

Investigate using softphone.

Converting from Fiber connect to IP connect will require a system wide reset 4 to remove the fiber links completely

Look into disabling the Network region that the phone and gateway are in on the Core Pabx. This should drop phones and gateway into LSP. Assumming that the NR are setup in a manner to allow this..

Try installing the software with the duplication Ethernet and fiber unplugged.

Also check if the FTP server will allow more than one concurrent users. Maybe you have more than one ftp backup running at the same time (give or take a few seconds). I normally stagger the backups by 20 mins. Check your schedules.

The translation are actually sent over the corporate interface of the active S8710 server. Can you ping it from the server. They are sent using FTP so that port needs to opened on any network firewalls. Also I have seen that if the network MTU size is lower than about 1470 then it will not work...

What version of firmware is the 1608 running, I am sure I had this issue resolved by firmware upgrade

You may have to go to page 3.

The command is "change tone" and it is run on the PABX (cm). You didnt mention what version of software the pabx is running.

Set up outcalling on station A VM box to ring the B phone when a message is left. Not a light but it is a possible solution to your issue.