Recent content by BCMTinkerer

Putting 0 in the specific tab works fine but if i have a seperate auto att for a different department i will need to send the calls to a different extension

111 is a system extension assigned to a phone,,,i have 0 as a shortcode that dials exte 111 (Receptionist) that works internally. The auto att pronpts the caller to press 0 to reach the receptionist i have the menu choice 0 in the auto att pointing to a transfwer block or cell That bloc is set...

Voice mail pro auto att menu,,,give callers opt to 0 out to got to a specific extension,,,have 0 pointing to a transfer cell, transfer cell points at ext 111 but when i press 0 it hangs up on me.

Thanks,,, I used the leave option in vm pro,,,works perfect,,,

How can i make a incoming did forward no answer to an auto att. Incoming call comes in, rings at the reception phone, if reception does not answer i want it to go to auto att. IP Office 8.0 (44) Voice mail pro

yes both ways

Yes

I performed a keycode upgrade on a 81c to convert to cs1000 and added a sig server, the keycode sheet reflects the system as being a cs1000 but in the system it still shows as being an 81c. After installing the sig server software and accessing element manager the web page shows Unknown call...

i am trying to pass DTMF over SIP to a 3rd party decice. I dial the device but once connected i can not press buttons to navigate. Any thoughts

Figured it out,,,,need to define businesws name in order to pass the name. Thanks

How do i get the name display to pass over SIP trunks,,,,now i only see H5300 when i call from the bcm to the cs1K In ip trunk settings,,,send name display is checked the target lines have caller id set checked the set has a name the set has a private oli the sip route is private.

is 90 the highes after applying the SRG keycode? Is there a doc to support that so i may review?

How many phones can be registered through an srg 50 back to cs1k?

I have a 4 port Nam,,the ports reside on 301, 302, 303,304, When a caller hits port 303 they get a fast busy,,,when i disable the port my 3rd call hits 304,,,is there a way to reassign the port?

when i navigate to the NETWORK INTERFACE tab through element manager the information is not displayed,,,i am trying to view the settings for lan 1,,,the page does not populate.