Recent content by alfalfa

Come to find out, if you have a customer who replaces his/hers vmpro server,and if they had a license dongle that was Parallel,and if the new server for vmpro does not come equiped with a Parallel port and the cust goes out and buys one. The license dongle will not work on the newly installed...

are you using ars or system short codes, and if using system short codes is there anything for 411.

the cust has 2 pri's no analog lines, plus i have even turned off vm and then you get a busy signal if calling the did. and yes the allocated interval time is adjusted, the cust states it worked for 2 days and remember this is a trial license,

I have a cust that has recieved a trial license and had it working but now it does not, she states that the licence was installed a few days ago, I have checked her system,they are running 3.2.54, and her license shows expirary 20/4/2008, the user has mobile set with number fiels 91 then number...

I have a cust with ipo 500 4.1.9 that is running ecas and using cdr to get info to ecas, on the reports in ecas they are showing under ext field 99999, ----------, and * Does anone know what the 99999 actually is have seen mention of it in other threads but never -------, nor *

I have a lab 500 with license, and using 5410 sets in my setup, my provider is cebeyond, which has given me info of their name, ???????sipconnet.cbeyond.com and i have a telenu,mber as user id, and a password, looking at the sip trunk form, i do not have an address to put in the itsp address...

I got everything to work after i upraged pc card thanks everyone, I have one more question though, how or is there a way to change the normal transfer funtion in AA menu options to get rid of the 1 then ext number, for instance right now i dial my AA it states if you know your parties ext dial...

how do i check what version of embedded vm it is, also to answer pure gold sc 400 feature attendant, telnumber AA:IsleAAOne.1 When i dial 400 it gives me the prompt to listen record or erase. Hunt ggroup main 200 ofmain hunt group-201 user FwdAtt with fwd hunt group calls, on and uncond. to...

I have a new install on a 406 v2 with embedded vm, never used it before today, all our cust use vmpro. anyhow, i created AA1 and AA2 followed the instructions to record prompts, set up user with uncond fwd to shortcode to play AA1, Read and did all that, but in my tests on version 4.0.10 I...

how about the trash

I have tried everything different pc's laptops trying to connect to the dte and yes i can connect perfectly with any other operating ipoffice using same cables, but yes different cables have been used even an ace of ipoffice had tried to fixe this and nothing

everything is already out. no daughter cards only the 406v1 my laptop connection via lan and com port to dte. This like i said i have never seen, it seems that i can't get passed the loader to enter any commands.

I have a 406v1 that came from a customer site after trying to do an uprrade from 3.1.65 to 3.2.55, Freaked out and now it ic not rebooting persay if you look at the led lights they remain constant, but if you go through the dte port and try to hyper term in you can't. Hyperterm keeps texting...

so my standard 5ess switch type like normal setup is fine on my end

i am cutting with ceboynd that has cisco iad router, it has been my experience that when you use a router it becomes a gateway and the only way to effectively program the merlin magix ds1 is to set it up for network-pbx, i have a cust though that needs caller id with network you loose cid. has...