Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

WinFiol cancel command

Status
Not open for further replies.

danlilea

Programmer
Jul 12, 2012
51
RO
Hello,

Is there any way to cancel an command that was send to the PBX and which was wrong, as the PBX don't provide an error or syntax error. Any cancel operation other than break and reconect.

Thanks.
 
If the command is wrong with a syntax error, the PBX does give a message!
If the command is OK and executes, then you can undo it by performing a data reload or input a command which reverses the action.
 
I meant if the command is written wrong with no syntax error like an command without ;
 
CTRL+B or CTRL+F in TTY mode will it.

///doktor
 
Ctrl+B Select all text from cursor position

Ctrl+F Find a string

That's in WinFiol HELP shortcuts
 
If you have sent e.g. a printout command giving a very long printout this printout can be interupted by:
CTRL+B pauses the printout or CTRL+F "kills" the printing job - but it has to be in TTY mode .
Other commands may be interupted by CTRL+F.

///doktor
 
That would be control+X F;
and control+X B;
 
Right, himdp.
Must have been too long since I used it.
The correct ´syntax is:
That would be control+X F;
and control+X B;


///doktor
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top