Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Upgrading MICS 4.0
- Thread starter blizkid
- Start date
curlycord
Programmer
Power down
Disconnect all 25 pair cables
Insert Tool card
Power up
When process is complete power down
Insert 6.1
Power up
When completed reconnect amp cables.
I think instruction are usualy on the Installer Manual under Upgrade.
=----(((((((((()----=
curlycord
Disconnect all 25 pair cables
Insert Tool card
Power up
When process is complete power down
Insert 6.1
Power up
When completed reconnect amp cables.
I think instruction are usualy on the Installer Manual under Upgrade.
=----(((((((((()----=
curlycord
- Thread starter
- #3
- Thread starter
- #5
curlycord
Programmer
Disconnecting 25 pairs is a precaution so static does not zap the cards.
Some here I am sure dont bother with it such as standing on a mat or grounding your wrist when hold cards.
Anyway my goof sorry.....
Power down
Disconnect all 25 pair cables
Pull out software
Insert Tool card
Reconnect amp cables
Power up
When process is complete repeat process but insert 6.1.
=----(((((((((()----=
curlycord
Some here I am sure dont bother with it such as standing on a mat or grounding your wrist when hold cards.
Anyway my goof sorry.....
Power down
Disconnect all 25 pair cables
Pull out software
Insert Tool card
Reconnect amp cables
Power up
When process is complete repeat process but insert 6.1.
=----(((((((((()----=
curlycord
- Thread starter
- #7
- Thread starter
- #8
Crap! My system defaulted.
Now, being the pesimistic tech that I am, I did write down all of the system programming before I started. That won't be too much trouble to put back in.
HOWEVER, what do I do about my PRI keycodes?? Any suggestions? I see that my System ID changed.
I think I messed up big.
Help.
Now, being the pesimistic tech that I am, I did write down all of the system programming before I started. That won't be too much trouble to put back in.
HOWEVER, what do I do about my PRI keycodes?? Any suggestions? I see that my System ID changed.
I think I messed up big.
Help.
curlycord
Programmer
I see you posted a new thread on key code recovery....which is ok but curious as to what happend.
Process:
4.0 to 4.1 then to 6.1.
If you weere not patient or disrupted upgrade then this would happen.
However one of my reps suggest that there was a certian verion when the id would might change upon upgrade....he could not recall what version this happens, I just assumed he was full of shit and still wet behind the ears as I have never had an issue.
Sorry for your loss, but contact an authorixed vendor and they can re-generate the keycode for you on the spot.
=----(((((((((()----=
curlycord
Process:
4.0 to 4.1 then to 6.1.
If you weere not patient or disrupted upgrade then this would happen.
However one of my reps suggest that there was a certian verion when the id would might change upon upgrade....he could not recall what version this happens, I just assumed he was full of shit and still wet behind the ears as I have never had an issue.
Sorry for your loss, but contact an authorixed vendor and they can re-generate the keycode for you on the spot.
=----(((((((((()----=
curlycord
- Status
Similar threads
- Locked
- Question
- Locked
- Question