SX 50 EQP-BSY 1

[pndb84]

I get A22 0061 LINE LOOP BACK ERROR 04/13 AND 08/07. Now,
04/13 make sense because there is an ops line card on slot 4 and port 13 but there isn't anything on slot 8 !! its completly empty. Any idea why I am geting that msg ?? and give me solution please...I've tried *31 and *32 many times but it comes back after a few minutes.

 

[pandabear1]

it may be your programing in the trunks, could you post your programing for one of the trunks that is in trouble, i.e. 501 to 580, just one of them.
Did a reversal help, that is a quick check before we go thru all the programing?

 

[pndb84]

No.

 

[pndb84]

Let me know what to do....


THOUGH, I feel great today...NO CALLS HURRAYYY !!!!

 

[pndb84]

501: R1011101000
R200001001
R3120002
R40510010000

Let me know if you need more info..

 

[pandabear1]

did Bell have terminate the new trunk onto the SX-50?
Do yo know how to view the programing and if so write down what is in the registers, if not we will start from scratch and guide you thru it

 

[pndb84]

they have....

 

[pandabear1]

your trunk card is in slot 1? I think your card is in slot 8 therefor your trunks will be command 573 to 580, check that program

 

[pandabear1]

hopefully they hooked the trunks back up the way they were before but let us check, the trunks should terminate on the BIX or whatever you have with trunk 1 on pair 1 then trunk 2 on pair 3 and so on, a pair is skiped after each termination

 

[pndb84]

you're right. trunk card is in slot 8 from left. but they all 573-580 have same data as 501 mentioned above.

 

[pandabear1]

my way of thinking register 1 should read as:
1101100010 this is counting the whole register all bits
your bit "i" is a 0 if I am reading this right and that is disabled

 

[pndb84]

pairs are skipped. He didn't mess with that part. Here is the connections: 6 pair of lines come out of bell side...they then go to another board where trunk wires are connected. he didnt mess with those connection.

 

[pandabear1]

where did you check for dial tone, should be where the trunk lines go into the SX-50. The SX-50 should wire out to a field directly and that is where you should check.

 

[pndb84]

yes "i" is 0

 

[pndb84]

that is where i checked....where land lines are connected with trunk wires. everything is fine till tehre.

 

[pandabear1]

change to a 1 and test

 

[pndb84]

LITTLE BETTER...

now one problem is solved. I can get incoming calls. but when i dial 9 i get leval 9-busy.

 

[pandabear1]

are the lights still on the trunk card?

 

[pndb84]

Yes. all of them are on

 

[pandabear1]

pull the card for 10 seconds or do a *32

 

[pndb84]

when system is on?