Setting up DTI Card Line in Use

[ski1535]

I'm setting up a DTI card. We have a T1 coming into a Cisco 2800 FE 0/1 port and going into the DTI card. This line is used to call a remote branch with 200 extensions. So when a user presses 2 the call is routed to the remote branch.

Here is what I have:
MBM Bus 7
CO Fail TIA-547A
Interface Levels ISDN
Framing ESF
INternal CSU On
CSU Line Build 0db
Line Coding B8Zs

Provision Lines 61 - 84
All lines show Provisioned

Telephony Services
Missing line 61
Enabled lines start at LIne 062
All 62 - 84 lines show
Trunk Type E&M
Line type Pool H
Signalling Wink Start

Destination Codes
2
Use Route 002
Route 002
Use Pool H
Public

Extensions
Line Pool H

However, when I go to press 2 I get a "line in use" error on the display.

Also on the Cisco Router the link light coming from the DTI card into port FE 0/1 is not lighting up.

Am I missing something?

 

[hawks]

Is it a straight through or cross over cable going to the cisco?

 

[ski1535]

Crossover cable. And before my hardrive crashed, it was working.

 

[gecko202002]

Is the card showing enabled in the BCM?
What kind of lights do you have on the T1 card on the BCM?

 

[ski1535]

I think I figured it out. The cisco router had the DE0/1 port deactivated.