Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Setting up DTI Card Line in Use

Status
Not open for further replies.

ski1535

IS-IT--Management
Jun 17, 2008
128
US
I'm setting up a DTI card. We have a T1 coming into a Cisco 2800 FE 0/1 port and going into the DTI card. This line is used to call a remote branch with 200 extensions. So when a user presses 2 the call is routed to the remote branch.

Here is what I have:
MBM Bus 7
CO Fail TIA-547A
Interface Levels ISDN
Framing ESF
INternal CSU On
CSU Line Build 0db
Line Coding B8Zs

Provision Lines 61 - 84
All lines show Provisioned

Telephony Services
Missing line 61
Enabled lines start at LIne 062
All 62 - 84 lines show
Trunk Type E&M
Line type Pool H
Signalling Wink Start

Destination Codes
2
Use Route 002
Route 002
Use Pool H
Public

Extensions
Line Pool H

However, when I go to press 2 I get a "line in use" error on the display.

Also on the Cisco Router the link light coming from the DTI card into port FE 0/1 is not lighting up.

Am I missing something?
 
Is it a straight through or cross over cable going to the cisco?
 
Crossover cable. And before my hardrive crashed, it was working.
 
Is the card showing enabled in the BCM?
What kind of lights do you have on the T1 card on the BCM?
 
I think I figured it out. The cisco router had the DE0/1 port deactivated.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top