I'm having a problem with my Rad I keep getting a message that says Feature in use. I have looked at the port in programming and it is on idle. I have diabled it and reinabled but same message comes when I do Feature 9*0
Is it a good port, hook a phone to it to see if it comes up.If so power the rad down and up again, then you should be able to see the rad..Do you have a power light on the rad. If that dont work if display still shows inactive feature,send it back..
I have checked all that on the Rad it has power and the port is good. I have even moved to another port. Any time I call in and do the Feature 9*0 is says feature in uses
I have unpluged the transformer and that did not seem to work. Feature 9** works I even changed the password to see if that would do anything. Some how it is hung up?????????
Default the rad and then try again. There is a post in the f.a.q's on how to do that. When you try again make sure there is no cable plugged in to the serial port.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.