Having problems getting paging to work on MICS:
Software is 4.1
Paging on all sets enabled
Connecting to a Bogen Gold Series 60 (this pages fine if I connect it to a Partner ACS)This unit is capable of accepting a 600 ohm page source.
Amp is connected to Blk/Sl pair
System pages thru sets fine
tested amphenol to 66 block= OK
also tried connecting to an 824, still NG
tried another amphenol, NG
Butt set connected to blk/sl pair yields nothing (nor on the 824! or the partner ACS!)
Any ideas??
Regards,
Ron C
NBSTel
Software is 4.1
Paging on all sets enabled
Connecting to a Bogen Gold Series 60 (this pages fine if I connect it to a Partner ACS)This unit is capable of accepting a 600 ohm page source.
Amp is connected to Blk/Sl pair
System pages thru sets fine
tested amphenol to 66 block= OK
also tried connecting to an 824, still NG
tried another amphenol, NG
Butt set connected to blk/sl pair yields nothing (nor on the 824! or the partner ACS!)
Any ideas??
Regards,
Ron C
NBSTel