Paging on an MICS

[nbstel]

Having problems getting paging to work on MICS:

Software is 4.1
Paging on all sets enabled
Connecting to a Bogen Gold Series 60 (this pages fine if I connect it to a Partner ACS)This unit is capable of accepting a 600 ohm page source.

Amp is connected to Blk/Sl pair
System pages thru sets fine
tested amphenol to 66 block= OK
also tried connecting to an 824, still NG
tried another amphenol, NG
Butt set connected to blk/sl pair yields nothing (nor on the 824! or the partner ACS!)
Any ideas??

Regards,

Ron C
NBSTel

 

[senk1s]

external paging has 2 paths (pairs 15 and 16)
one for control(relay contact closure) and one for voice (page)

 

[nbstel]

not sure that I need the contact closure (although I could be wrong). amp is set up for telephone paging and it works with just 1 pair from the partner acs.

 

[bkrike]

there are at least 3 amp cables from MICS- are you on the correct one?
Which one are you on?

the statement regarding "also tried connecting to an 824, still NG"- what is that?

And then… "Butt set connected to blk/sl pair yields nothing"- what does that mean?

 

[Justatec]

Its a mics, should be on 15... ics on the other hand its on
v/s,s/v or pair 25. external page on pair 24..

 

[Justatec]

Think they mean pair 15, And then they page and didnt here any thing

 

[nbstel]

Got it. Thanks all.

 

[bkrike]

Why dont you post the solution so you can help future generations???

 

[nbstel]

No rocket science here! I wasn't on the second station amp!

 

[bkrike]

I win

 

[nbstel]

Indeed, you have!! The second station cable was not wired and I missed it.

 

[Justatec]

Thanks,, It has happen to some of the best,