Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

No CDR output

Status
Not open for further replies.

Nasredine

Programmer
May 1, 2022
33
DZ
Hi,
I'm trying to activate CDR. I'm not the one that has configure it before, so I'm not sure if it was done properly.
When I execute : DIS-LSSM; I've the server activated but when I try to log into it to get records using SSH or Telnet, I got timeout error.
Any help.

********* RMX : LOGON at 2022/12/16 08:46:46 ONLINE BATCHPROCESSING ********

*** HICOM-Nr: RMX Contract: 00 Name:

L01: LOGON ACCEPTED TSN 3226 ALLOCATED 22-12-16 08:47:07
<DIS-LSSM;

DIS-LSSM;
H500: AMO LSSM STARTED

+=========================================================================+
| STATE OF LAN - CHANNELS |
+=========================================================================+
| | | SYSTEM | USER |
| TCP- | STATE |=========================================================|
| LINE | | IP ADRESS | PORT | IP ADRESS | PORT |
+=========================================================================+
| 1 | ON | 192.0.2.3 | 1201 | 0.0.0.0 | 0 |
| 2 | ON | 192.0.2.3 | 1202 | 0.0.0.0 | 0 |
| 3 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
| 4 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
| 5 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
| 6 | ON | 192.0.2.3 | 1206 | 0.0.0.0 | 0 |
+=========================================================================+

AMO-LSSM -111 LINE SWITCH, SERVICE MODULES
DISPLAY COMPLETED;
<***** ***** AMO run time 00:00:01 *****

************************* RMX : LOGOFF *************************

*** HICOM-Nr: RMX Contract: Name:
 
After only executing "DEA-SELS:1.", the transmission of data flow commenced; however, only a partial amount of data was transmitted, omitting the records from July.

@masviss, could you clarify whether this command has the potential to result in overflow issues? If it does, kindly provide the command necessary to deactivate SELG.

Best regards.
 
The command
DEA-SELS:X;
only disables data transfer in the storage area,
from where this data can then be read.

The command
ACT-SELS:X;
turns on the transmission.

That is, if the SELS is activated, the data is recorded
and occupies a dedicated storage space.
After reading the data, they are deleted.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top