Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICS PRI Enabler Code

Status
Not open for further replies.

rkartevold

Vendor
Jan 24, 2006
15
US
Other than turning up a PRI (Circuit) and plugging it into the MICS, is there any way to tell if an Enabler Code has been installed? I'm being handed an MICS (7.0) with DTI and Combo Card (Used System) and the owner says that it had a PRI before. Anything in the Programming to get me to the point of telling PRI Code is there?
 
as long as you can change the card to PRI under hardware settings
you have to disable the card first
if you cant change to pri then there is no enabler code
 
If the sytem has pri code alreay you will also lose the code if you do a F**Startup or down size the system
 
Under hardware it shows cd-1: KSU PRI so I guess it's OK. Thanks for the tip. It's one I won't forget.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top