Hello All,
I'm having a very strange problem with a MICS system. I can configure sets and lines, log out, login, and verify that everything is the way I set it. The problem is that the none of the settings are actually being applied.
For example:
I can set a particular feature on a phone set button and verify the the button setting is correct, but when the button is pressed, it is not the feature I set.
I would appreciate any and all advice on what would cause this. I have tried everything I can think of. The system was fine until we shut it down to move it to another location.
The software version is 7.1
Thanks,
-S
I'm having a very strange problem with a MICS system. I can configure sets and lines, log out, login, and verify that everything is the way I set it. The problem is that the none of the settings are actually being applied.
For example:
I can set a particular feature on a phone set button and verify the the button setting is correct, but when the button is pressed, it is not the feature I set.
I would appreciate any and all advice on what would cause this. I have tried everything I can think of. The system was fine until we shut it down to move it to another location.
The software version is 7.1
Thanks,
-S