IPO to IPO PRI Config 1

[mcnutter1]

I am trying to configure a point to point PRI between two IPO's using a T1 Crossover cable. I am able to get the link up and I have light on both ports. The manager shows the channels are up.

I started to configure inter-pbx 4 digit dialing but I am stuck. When I dial an extension on the other IPO i get a busy signal. This is what I did so far:

1. Configured the PRI's one IPO as CO and the other as CPE
2. Configured 4 channels on each PBX as line group 1
3. Configured a short code of 8N to dial that line group.
(I would like to dial the extension without the "8")
4. Configured ARS to dial the other PBX
5. Configured an incoming route on each pbx for that line.


So far this is as far as i have gotten.

 

[amriddle01]

mcnutter1, for the name you would need a licence. Unless using a U in the shortcode for dialling out would send it....I doubt it

ACS - IP Office Implement

"What the Crocodile Hat....was that?