ipo 403 booting problems the saga continues

[jonta]

thanks for all input
we are getting closer to the end

please see attached screen dumps of dte output (hyperterminal) and tftp output
i deleted the config and firmware
i set up a boot p
and as you will see from screen dump the 403.bin file has been sent to the unit
however the unit is in a continuous boot mode now with the dt green leds counting up from 1 to 8 four amber leds continuously lit on ports 2,3,6,7
also lan port drops as unit reboots
also i did get following error from dte port
soak/diagnostic test
mac = 00:E0:07:01:21:B5
STATUS NUM = 6000 PASS = 1
FAILED CODE = 1 TESTNUM=6000
(WAN1:V28 PATTERN IP=0000, OP=007F (NOT 0000)


i can not attach screen dump

 

[Escorthosis]

Does your unit have a VCM card installed?

I've seen those cards go bad and taking the whole system in a continuous reboot.
So take all the additional cards (Trunks, VCM) out of your unit. Get it working and then reinstall the cards one by one to see which one was the culprit.

 

[ProviderReborn]

What bin file are you loading into your 403?

ACA - IP Office Implement
ACA - IP Telephony
ACS - IP Office Implement
CCNA - Working towards.

 

[intrigrant]

Send it to Avaya for repair.

NIHIL NOVI SUB SOLE

 

[kwing112000]

Jonta,
Have you read any of the replies? You keep making new threads but dont give any answers?

 

[jonta]

ip403 not booting saga
thanks for all input
escorthosis pointed me in right area
fault was a faulty dual modem card
once removed system booted okay and is now working

thanks again

jonta

 

[PotNoodleBoy]

I had one the other day with a faulty VCM. We'd tested the VCM in a 406V2 previously and it worked. After removing it from the rebooting 403 and trying it again in the 406 it also failed to work there. Oh yeah, and when we removed it from the 403 we found it had managed to wipe the software from the box.

Glad you got it working.