ei guys, I have a gsm gateway connected to a trunk port to my IPO. Maybe you could post the proper way to configure it. I'd just configured it like a typical analog trunk and didn't work. I'd also connect the GSM gateway to a working analog trunk port but still failed to route a call.
Another problem also is when I attempted to dial out the desired number it will go try to connect the call even the dialed number is not yet complete. For example, I want to dial 091xxxxxxxx, then it will dial out without the last 2 digits. TIA.
using short code;
9N
Dial
N
51: Dial 9
my ARS config:
code:091
TN:091xxxxxxxx
F:dial
ID:6
Another problem also is when I attempted to dial out the desired number it will go try to connect the call even the dialed number is not yet complete. For example, I want to dial 091xxxxxxxx, then it will dial out without the last 2 digits. TIA.
using short code;
9N
Dial
N
51: Dial 9
my ARS config:
code:091
TN:091xxxxxxxx
F:dial
ID:6