cctech1956
Vendor
Hello all: I have an IPO500 V2 With a Valcom 2001a and have not been able to get it to page over external speakers. I came into this after someone had already connected paging and was not able to get it to work. It was setup on an analog extension (201) with a short code of *61. When the paging button was pressed paging was heared through the speakers of the phones but not the external speakers. I looked at the programming setup and it appeared to be correct the way that I read on some of the threads on this forum. I thought it would be a good idea to use a line port, so I tried to setup CO 7 to be my paging port but it didn't work either. I read another post on here that said when you use a line group ID that you must also delete the previous line id that was using that group. I did not do that when I was setting it up. That information was not included in the instructions on how to set up a line port for paging. I am concerned that I am not doing all the steps and that is why it is not working. Is it possible to get a step by step list on how to program a CO port for paging. And after I set it up, should I be able to plug my butt set directly into the CO port on the IPO and make a page.
Thanks, for any input.
Thanks, for any input.