stcroix1
Technical User
- Feb 15, 2007
- 41
We had an IP500 4.2(4) with a DS30 and DS16 crash last Friday. It is on our LAN and in another state so I could not access it remotely. We had a tech go out and unplug the two expansion modules to see if the control unit would stay up, it would stay up for a minute then flake out again leading us to believe it was a problem with the control unit, bad PSU? I had a spare control unit and feature key smart card (that we were going to use at another location on our LAN) so I upgraded it and sent the backup config into it. It said the license was invalid but I figured once it was onsite and the tech swapped the analog trunk cards, embedded vm cf card, and feature key over to the replacement we should be good. It did have 2 alarms concerning features we dont use and I dont remeber what they were. Everything worked fine for about 12 hrs but now it is behaving the same. Blinking red lights on the DS modules and cant access the control unit via LAN. Any ideas on what the issue might be would be appreciated.