How to disable a permanently out of service trunk?

[KaLLiSToi]

IPO 500 unit. Recently we have added an E1 trunk in order to replace 3 BRI trunks. The TelCo cut off the BRI lines and now I am getting "Out of Service" alarms for the 3 BRI trunks. Is there a way to disabled these 3 BRI trunks?.

Thanks in advance.

Regards.

 

[ddrib]

For each BRI Trunk change the following to:

Number of Channels: 0
Outgoing Channels: 0
Voice Channels: 0
Data Channels: 0

cheers

 

[amriddle01]

Or take the card out the system and remove it from the programming

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers

 

[KaLLiSToi]

Can't remove the card, it's a Quad BRI and the 4th BRI is supporting a GSM gateway. Anyway, the solution of ddrib works fine.

Thank you all again!

Best regards.

 

[SeeThru]

I've had to do this on a line - I set it to outgoing 0 and incoming 1, but will switch to 0 and 0 now. Thanks!

SeeThru
Synergy Connections Ltd - Uk Telemarketing and Telesales Services and
Synergy Mobile Solutions - UK Mobile phones, land lines and call packages

 

[tlpeter]

Just set the channels to 0 or make it an S0 port

ACS - Implement IP Office
ACA - Implement IP Telephony -- ACA - Design IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!