What help do you need? whats the spec of set, Eg expected line voltage? the set termination (Rj11/ Rj45)? or do you need just to set up an Analog extn?
if your sidetone is a little loud, then your rec may be distorted.. use a resister to drop the voltage.. unless things have changed that is a lower voltage unit.. it will not hurt to operate it at a higher voltage..
hello every body:
the broblem am handelling that i want to connect a field telephone ( TA-57 ) to my meridian1 system for military purpose with no voltage on the line from the PABX but just ring signal with 48v ( LB )type so can you help me?
with my best regards
thank you:
i connect the field telephone to the trunk card but what about the ring to the telephone?
i want to send a ring to the field telephone.
so do you solved this problem?
to send ring voltage to the station.. build your trunk as a cot, start type imm.. the build a rlb pointing to that route, then add a dsc pointing to the rlb.. might need to play with start type but that is the way i would attempt to build a workaround..
you can't switch the field phone to common battery? i know local battery is what makes field phone work but the ones i played with could use the common battery mode..
hello:
the TA-75 worked with the meridian on the co trk for incoming but the he problem is to send a ring voltage to it i tried what lohnpool send but the problem is that idiid not found the start on trunk programming but just in the NTPs
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.