ERR404 0 no default tree exists

[KPTraill]

I am trying to test my lines by dialing the route access code, drawing dialtone, then dialing my cell phone number. Everytime I begin dialing I get a busy tone and ERR404 0 on the tty. What is the default tree and where is it?

 

[worldwidedialtone]

Can you access your trunks via a maintenance set and puul dial tone from provider?

MIKE

 

[acewarlock]

Are you sure your dialing a Trunk access code and not a special number. Print your RDB and make sure of the Access code for that route.

Once you have trunk dial tone you should be able to dial anywhere.

 

[fritzthecat]

Hi,

check your FRL`s in load 21 Rout data block, then veryfy if they are configured in LD 49

That will probably fix your problem

regards

Fritz

 

[acewarlock]

Print your RDB's and check to see if the access code your dialing has a TGAR/TARG stopping you from dialing out.