Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Enabling Media Encryption on Avaya Aura CM 3

Status
Not open for further replies.

bryankich

Technical User
Oct 1, 2015
13
US
We have a need to enable media encryption on all of our voice traffic that did not happen during the install of our new system. I am still learning the ropes and having trouble getting this enabled.

I have checked display system-parameters customer-options and found Media Encryption Over IP? set to y

So I went ahead and moved my extension to a test network region and set a new codec to use G.711MU with media encryption set to aes

Now when I pick up the handset I receive no dial tone and below is a list trace on the station. Any guidance on what im missing would be very helpful.

Code:
LIST TRACE

time            data

10:53:19 TRACE STARTED 10/01/2015 CM Release String cold-03.0.124.0-22450
10:53:22     denial event 1644: Orig block/invalid digits D1=0xa6 D2=0xb103a38
10:53:22     active station      1293 cid 0x3a38
10:53:22     denial event 3731: Incompatible caps for end D1=0x7f00007f D2=0xa6
10:53:22     denial event 2300: Ept capabilities mismatch D1=0x4 D2=0x4

 
I have the same problem, I need to enable SRTP, but I have checked display system-parameters customer-options and found Media Encryption Over IP? set to n.
I read a document, Configuring Avaya CM for Media Encryption Issue 1.0, and it indicates that if the Media Encryption feature is not enabled, a new license must
be obtained before following the remaining steps in these Application Notes. I launched the WebLM and show I do have the license.
Feature
(Keyword) Expiration Date Licensed Acquired
Media Encryption (FEAT_CM_ME) permanent on Not counted

We are using an Avaya Aura CM 6.0.

Is there something else I need to enable or set to get Media Encryption Over IP? to flip from n to y ?

Thanks.
 
In your CM webpage, on the top, there's "licensing" and there's a spot you can do "feature administration" where you activate certain features permitted in your license.

Check there.
 
Thanks Kyle. Never even bothered to look at that. Still have a lot to learn.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top