Hello All,
I am having a difficult time getting up an H.323 trunk for the connection between the IPO and the CM...
CM is a 5.2.1 and the IPO is 6.0
I have done IP trunks between these two system types before just not on these versions.
I seem to have the trunk programmed correctly and just for the sake of checking I read the Avaya doc on this and all my setting were as they should be.
the IP office side through System Status shows all channels in an idle state, however the CM side has the Signaling Group in-service but all my trunk group channels out of service NE...
I can figure out what I could be missing, anyone have any suggestions?
I can figure out what I could be missing, anyone have any sugestions?
Brian M Battagliola
I am having a difficult time getting up an H.323 trunk for the connection between the IPO and the CM...
CM is a 5.2.1 and the IPO is 6.0
I have done IP trunks between these two system types before just not on these versions.
I seem to have the trunk programmed correctly and just for the sake of checking I read the Avaya doc on this and all my setting were as they should be.
the IP office side through System Status shows all channels in an idle state, however the CM side has the Signaling Group in-service but all my trunk group channels out of service NE...
I can figure out what I could be missing, anyone have any suggestions?
I can figure out what I could be missing, anyone have any sugestions?
Brian M Battagliola