Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

4610on IPO 403 soft 3.2

Status
Not open for further replies.

d14v0l0

ISP
May 31, 2006
59
RS
I have IPO with 3.2 software and several ip phone 4610. On central
location all phones work correctly. I have one remote location and
on that location phone work fine except display. Display is blank.

The same phone work on central location, and phone from central location
have same problem on remote site

Why?
 
What type or Routers/firewall in between, if it is cisco you need to turn off the fixups

Kevin Wing
ACA- Implement IP Office
Carousel Industries
 
I must check, yes all network equipment is cisco.
 
Ihave seen this and it usually is the fixups. Take a look at them and start turning them off and see when the display comes up.

Kevin Wing
ACA- Implement IP Office
Carousel Industries
 
Sorry for long no answer.
I upgrade firmware and display on phone start to work properly.

TNX any way.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top