Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

200 light upgrade 1

Status
Not open for further replies.

zete

Vendor
Jun 17, 2010
73
US
Is there any way to move the CDE Database from a 200light to a 200el?
 
the backup should be uploadable - what are the relative sw loads

**********************************************
What's most important is that you realise ... There is no spoon.
 
Hi kwbMitel:
I am running Q47.xxx...... in the 200EL. Also since the 200Lt does not designate the control cabinet and the 200EL is Bay 1 what will I do with that?
The new 200EL will utilize triple control Fim cards in slots 10 and 11 and in the 200lt there is also a T1 in it's Bay 1.
Do you think the 200EL control Bay1 cabinet will be able to power both slot 10 and 11 triple fims for the 6 bays as well as the (7) 12cct cards that is in the 200lt bay 1 cabinet as well and the T-1 card which is now running in the old Bay 1 as well?
Zete
Thanks kwbMitel
 
It's been too long since I've done one of these

I'd forgotten that control cab on the light was separate

At one time mitel provided cdbar (change DB across revs) but I doubt they support that anymore

Looks like hand punching to me

**********************************************
What's most important is that you realise ... There is no spoon.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top