Search results for query: *

Try feature 984

Guys, I had the customer reboot the system and all is well. Thank you all for your time and experience. gmiller1949

Allworxguy....tried Firefox with no success. Curlycord....when I get to the password prompt, I'm connected. When it fails, I don't get to the prompt, it just stalls. Sorry if I was not clear. Anyway, I'm going to have my customer reboot on Friday after COB. Stay tuned, I'll post my results...

I asked the customer, but timing is not right. The system is functioning properly except for remote access. Will reboot after COB this Friday. Stand by for my update. Thank you.

I'm using Windows Internet Explorer ver 9.0.23 I enter the IP address of the CP150 in the subject line and it takes me right to the password prompt using AT&T MPLS cloud network. I have 32 systems across the country, so direct connect is not available. All systems work with exception of about...

We have several 0x32 Nortel units w/Call Pilot 150. Typically, I enter the IP address (of the CallPilot)in my browser subject line and connect. Recently, I cannot connect. The Call Pilots are functioning, answers to "PING", all LED's are lit and I can access via the RAD using feature 983. I just...

We have several 0x32 Nortel units w/Call Pilot 150. Typically, I enter the IP address (of the CallPilot)in my browser subject line and connect. Recently, I cannot connect. The Call Pilots are functioning, answers to "PING", all LED's are lit and I can access via the RAD using feature 983. I...

yes, that's what we are doing now. Big boss wants a LAB with everything mounted in racks and was asking about the MICS.

IH17, thanks for the response....that's sort of what I thought.

does anyone know if Nortel makes a bracket to mount an MICS in a relay rack such as Chatsworth 19" ?

Yes, the old 1A2 is a system by itself, as is the Norstar. You tie the T/R from the 1A2 to the CO of the Norstar and connect the A1 leads of the lines and the two systems work very well together.

Sure does. using Norstar 1A2 trunk cartridge. Tie the A1 leads together and you even get light supv on both systems.

yes, it is a very old system. Even has 1A2 key equipment attached (Verizon C.O.). This is a trouble not a new install. We may ditch everything and move on to a BCM.

I have 0x32 w/ XC1.1 I need to enter the PRI enabler code, but "HARDWARE" does not appear in configuration.

Dasheen, yes, that is what I do....I was hoping for a fix to have the DN's appear as they should. Thanks gm

Then I lose my config. If I back-up the config, then expand the system and restart, will it take a restore with the new hardware in place?

This happens to me a lot. I install a 6-port expansion card and a fiber station module plugged into the bottom port. I should have sta 253-268, but I get 269-284 or 285-300. What am I doing wrong? How do I prevent this? gm

thanks....I think the AA menu prompt is my solution. I'll test it on my work bench

I have a CallPilot 150 ver3.1 My customer wants to disable the AA after hearing the greeting. Can we turn her off and how? gm

I'm trying to connect a CAP module to a 7310 and it will not boot. Any suggestions? Works fine with a 7324. gm