OK, thanks everybody for your input. I had my hardware installation guys test the fiber since they were connected via two patch panels. It seems once the GBICS were rolled on the 6509 the connections came up. Again all input was appreciated and thanks for taken out the time to evaluate the...
Thanks Andy for your input, however I am very familiar with vlans and the trunking principle. There is a reason why I deploy these switches the way they are. My question did not incorporate if this is a correct topology but rather if there could be another reason than a layer 1 problem that I am...
I am trying to connect 6 2950s to a 6509 switch via portbased vlan. We supernetted the ip and herewith use an extended VLAN. All switches will have the same Vlan applied, lets say Vlan 1500. Her is the config of one of the switches:
The port on the 6509 is configured for VLAN1500
version 12.1...
Can somebody tell me what exactly would happen if two connecting atm interfaces were transferring data with pvc 1/32 (expl) one configured with encapsulation aal5snap and the other one not. Would this create a delay, or a complete miscommunication? Is there a command I can use in order to...
I have heard that there is a way to connect to sup2 from sup1, can somebody help me out on the syntax.
Sup2 is in "other" status and I am unable to access the mod via console session. I am also unable to take down this switch in order to bring up sup2 since we cannot afford any downtime. The mod...
Yes it is:
interface ATM2/0.1 point-to-point
mtu 1500
bandwidth 6144
ip address 10.1.132.66 255.255.255.224
ip nat outside
ip ospf cost 48
ip ospf hello-interval 1
ip ospf retransmit-interval 3
pvc 1/69
vbr-nrt 9264 6144 100
max-reserved-bandwidth 95
oam-pvc 0
encapsulation...
Please someone tell me why this is indicating 0kb bw available
Here is the complete config output:
router1#sho queue atm2/0.1
Interface ATM2/0.1 VC 1/69
Queueing strategy: weighted fair
Total output drops per VC: 0
Output queue: 0/512/64/0 (size/max total/threshold/drops)...
Hi,
ping is successful to primary after shutting down the Interface of the secondary....ok standby use-bia....is related to the MAC address, but let me see if this is the problem...Thanks for the brainstorming...
Connie
Cat6k-MSFC
All other vlans are configured the same: primary and secondary router on the specific vlan have HSRP enabled with DG as 10.73.22.1
For some reason I am unable to ping the DG, but when I disable the interface on the sec router I am able to ping it.
Prior to disabling the Interface I am...
It is unclear from your information if this is a new ACL or an existing one. Whenever you modify an ACL, you will have to replace the complete list. Just copy to a notepad, add new permit/deny statements and past back in to the router.
Connie
Hi,
I need to retrieve a break-down of a HSRP frame from my router. The router exists on a remote location and the support group located at this site does not have a tokenRing sniffer. I understand there is a debug command that provides the same information as a sniffer. I tried a couple of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.