Hi,
I need to retrieve a break-down of a HSRP frame from my router. The router exists on a remote location and the support group located at this site does not have a tokenRing sniffer. I understand there is a debug command that provides the same information as a sniffer. I tried a couple of debug commands but it does not give me the sufficient information. I need to determine if HSRP is set to '2' instead of '1' which is the default setting. This would indicate a software bug with CISCO on this IOS. Any help is appreciated. This is a 5000 series...
Thanks
Connie
I need to retrieve a break-down of a HSRP frame from my router. The router exists on a remote location and the support group located at this site does not have a tokenRing sniffer. I understand there is a debug command that provides the same information as a sniffer. I tried a couple of debug commands but it does not give me the sufficient information. I need to determine if HSRP is set to '2' instead of '1' which is the default setting. This would indicate a software bug with CISCO on this IOS. Any help is appreciated. This is a 5000 series...
Thanks
Connie