Search results for query: *

you can identify a number to send to the PSAP in the network region form. Of course the PSAP would have to know that particular identifies your site address

Dosnt really answer your quistion, but why not utlize your sip/sbc trunks for all calls , not just for 911

Depends on your valcom unit, the do have some units that provide for multiple inputs

change console x and look at "common shared extensions

Rel 10.1 We are using Sip Avaya workplce on Iphones. On the Iphones we have a brige appearance of there Desk Phone, When the desk phone Rings (appearance on the Iphone) if the Desk phone is answered the Iphone continues to Ring, Any one have any suggestions? Thanks

And expect to pay double if you plan on helping them

Can also be done in the ip-network-maping form for ip stations

Upgraded to the new PSA version, Now am unable to back up announcments - getting Error can not connect to the VAL source CM 10.1 Can one of you try?

Send each selection to a new VDN, then you could pull a report on the different VDNs

look at your gateway settings...NR

We have a R10 to R7 H.323 tie line. On the R10 side all members are showing inservie/active. This has been working for 6 months and just got into this state. Have tried to busy - release the sig group and trunk group at both ends. also tried a reset system 1. Any thoughts appreciated

your just tryin to find all your users? you could change the cor/cos so they caint call out. then they would be forcd to call you with a trouble

Try playing with your config set. Calling Number Verification? n

I had to move a pri to a different slot and change the sync sourse in a G450, When looking at sync timing, both the primary and secondary sourse where happy. But the gateway still showed sync fault. I ended up re-booting the gateway to clear. Is there a command that i could of used instead...

i was just curious, im not convined looking at registrations in smgr is always accurate and wanted to compare what the SMs think compared to smgr

kyle nailed it, sm console Get RegistrationData the help on sm console gave lots of different syntax options Thanks Kyle

Anyone know how i can view sip user registrations via SM cli?

Bankrupt again, oh Joy So what happens when they go out of business? guess i need to start looking at cisco

Yes sir, Thank you!

Anyone know were the SIP station re-registration timer is set in SMGR? Have an application that does not seem to be ble to keep up with the amount of registrations it sees and want to slow it down