Search results for query: *

These are analog resident room phones and must be able to dial within the facility. I had already given that one a thought but was rejected. They are also on a PRI so the absence of D/T would create issues as well. Thanks for the response. We are just going to wait until that resident moves out.

Thanks....I did not think it was possible but had to ask anyway. I've never been asked to try to block an extension in the years I've been programming. Thanks again for your research and input.

Is it possible to block extension to extension calling on an MICS 7.1?

My bad this is a fast rad

The cable is a straight through cable and I started at the 9600 setting. I have tried all the cables I have to include a null modem. What about the upgrade on the RAD? Could this cause problems if they are older version RADS? Don't know.

I cannot direct connect to the RAD. I am using NRU 11.0. I have a dell latitude D520 and it has a serial port (Com 1). The serial port settings are 19200--8--N--1--flow control to none. I have tried on two different RADS and cannot get in. The program says initializing Com port 1 then RAD not...

NEC 12, and and 8X24 DR2

I have the exact same problem with an MICS. From out of nowhere the circuit will drop and sometimes several times a day. They are on LOGIX. I have swapped out the DTI card and the patch cable to the LOGIX interface. All of my alarms (75,42,43,and 44) all point to the LSP. LOGIX will bounce the D...

Sure would be nice if NRU could be used. No, I am not a GURU!!!

Disable outbound transfer in the COS. If someone needs outbound transfer put them in a different COS. Have the users use at least a 5 digit password, and set the attempts to 4. You can look in reports (mailbox information) and see if any mailboxes are set with any number for outbound transfer.

How can you find (without being on site) the RAM cartridge version. My software version is 5.0. How can I get the version of the cartridge? Where can I find the SP codes for up to 7.1 software.

Swapped out the KSU and it worked OK

It there a reset button on the KSU???????????

I find it odd that this would happen to what is supposed to be a brand spankin new system. It would seem to me that if you have virginity on behalf of both the system and the s/w, that they should be able to mate with no problems the first time.

OK the system was new in MORTEL box. It is V2 NVram. The system was tried without software and then with s/w and nothing has changed.

Have any of you ever ran across this before???????????

We are having the same problems with 2 different KSU's and two new s/w packs

That I do no know. It was on the wall when I arrived on site

This is supposed to be an all new system. Wireworks went to see if he has an older s/w version. If it works then maybe we do not have a new system. We will a no s/w boot up first.

yes I am working with wireworks