Looking at NRS under gateway endpoints call signaling IP is Not registered. I have set up the gateway endpoint Dynamic SIP, transport is UDP and Port 5060. On the BCM50 SIP Proxy Domain is the Domain listed under the Service Domain in NRS. I added a Outbound Proxy on the BCM with the Domain...
We our trying to make a tap cable to read Qsig messages for MWI, so we can send DTMF messages to trun on and off MWI light on a siemens 3700 gateway set. The 3700 is not Qsig compatable.
I'm being told that the Siemens need to have a DCH for each PRI. What I'm hearing is there is no problem having 5 PRI's with 5 DCH's in the same route with calls coming IAO on the route.
I have 5 QSIG PRI Routes each with a D-Channel going to a Siemens Hipath 4000. I have built a RLI with 5 entries to step to each PRI as they fill up. Would it be better to set all 5 PRI’s with 5 D-Channels in the same route or keep it the way it is?
On the Nortel it is LD 22 REQ= PKG then it will list all the package in the PBX and for QSIG is 263. You need also need the following packages 19, 145, 146, 154, 184, 202 for all the features to work over QSIN
I have set-up I1140 IP Set so I can login into it from other IP sets by entering the ext. and the SCPW 123. The Display of the set Local Mode (Thats Cool) but two lines Below that it shows Invalid ID (3) any Ideas?
DES 5597IP
TN 252 0 15 22 VIRTUAL
TYPE I2004
CDEN 8D
CTYP XDLC
CUST 0
NUID...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.