CS1000M with SIP Trunking

[dcross]

Has anyone networked a Cs1000M 4.50 with a BCM50 using SIP trunks and MCDN? I'm looking for the set up on the CS1000 and the BCM.

 

[pronei]

Not really a whole lot to setup on the CS1000, you just have to make sure your NRS is config'd properly with routing etc.

On the CS1000 you'll need CDP entries for the BCM that point to an RLI that references your SIP Route.

 

[dcross]

I have that set up on the CS1000 and in NRS.

 

[pronei]

Ok, so is it not working? or?

 

[dcross]

Looking at NRS under gateway endpoints call signaling IP is Not registered. I have set up the gateway endpoint Dynamic SIP, transport is UDP and Port 5060. On the BCM50 SIP Proxy Domain is the Domain listed under the Service Domain in NRS. I added a Outbound Proxy on the BCM with the Domain name that was listed under Service Domain in NRS, IP address of NRS and Port 5060. Can you see anythisg I'm missing?

Thanks,
Don

 

[pronei]

BCM has to be Staticly assigned, you can not use Dynamic on BCM.

 

[dcross]

Tried static did not work.

 

[lliesbthighs]

Have you programmed target lines in BCM?? also the SIP URI map should be same in both BCM and CS1000M
regards

 

[pronei]

Are you firewalled between the BCM and the NRS?

What are your SIP properties on your BCM?

Until you can get the BCM registered the NRS, your calls will not go through.

 

[dcross]

Target lines are programed, SIP URI Maps are the same as sig server, no firewall and SIP static IP set up in NRS. What am I missing?

 

[pronei]

On the BCM
Paste the settings on your SIP Settings tab & SIP Proxy tab.

Are the domains configured exactly as they are configd in NRS?