Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. jrzardo

    monitor bandwidth usage on a ISP supplied Cisco 827

    You can check if your IPS has management services. May be they have these graphics/data ready for customers access by web. Another sugestion is to check if your ISP can give you SNMP read only access to the router, then you can use a MRTG like tool to generate the graphs. []s Jeff
  2. jrzardo

    ?? best way to connect two routers together ??

    you can use a ethernet cross or two serial cabes, one of them will be a DTE and other will be a DCE []s Jeff
  3. jrzardo

    VoIP with Qos

    Hi secureinc, In a simple configuration, you can use "ip rpt priority 16384 16383 xxx" where xxx is the bandwidht you would like to priorize. I don't know what kind of codec you are using to say a secure amount of bandwidht to use. BTW, you can go to www.cisco.com and search for voip qos...
  4. jrzardo

    Slooooow Link

    Hi Djacbous, His this configuration complete? I'm not finding FR dlci on ser0/0 or another sub-interface like ser0/0.1. Can you post the config of the router on the other side of the link? In this config, I can see you have "frame-relay traffic-shapping" applied to ser0/0 but no map-class and...
  5. jrzardo

    Cisco 831 Virtual AUX port

    try to read this doc from cisco's web site... there is a section about DDR. http://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a0080118cbb.html []s Jefferson
  6. jrzardo

    How can i partition and format C

    you can try this: Router> enable Password: <password> Router# Step 2 Enter global configuration mode: Router# configure terminal Router(config)# Step 3 Enter the partition {slot0: | slot1:} [partition-number] [partition1-size] [partition2-size] command: Router(config)# partition slot1: 1...
  7. jrzardo

    Policy Based Routing

    policy based rounting is a IOS feature and not a hardware feature. I didn't check the cisco's web site, but i believe that the IOS IP only had suport. you can test if your router have PBR by triyng to set up a policy route and then attaching it to a interface. example: route-map test permit 10...
  8. jrzardo

    Connecting 2 sites via Cisco VPN (Cisco 2600 Routers)

    Have you tried to setup the WINS server???? []'s Jefferson

Part and Inventory Search

Back
Top